Cyrus 8 DAC Instrucciones de operaciones descargar pdf (Pagina 12)

Cyrus 6a, Cyrus 6 DAC, Cyrus 8a, Cyrus 8 DAC, Cyrus 8 Qx DAC User Instructions

TROUBLESHOOTING GUIDE

If your amplifier is not operating properly, disconnect the power and check

carefully all connections.

If you are in any doubt, consult your retailer.

No sound

The amplifier is switched off or in

Standby

Bring the unit out of Standby

(Standby light - GREEN)

Mute is on

Deselect Mute

The source is not working

(e.g. CD not playing or paused)

Check the source

No sound (digital sources)

The sample rate or sound format of the

digital signal from the source may not

be correct.

Check that the sample rate from

the source is within the

specification of the amplifier and

that the program is encoded as

two channel stereo.

No sound from one loudspeaker

BAL control at extreme limit Centralise Balance

Does your speaker have fuses? Check speaker, replace fuses

Speaker cables / interconnects faulty

Check connections, cables -

replace if needed

Spurious noises from speakers

Interconnects or connections faulty

Check, replace where necessary

Only one digital source is selectable

for Zone 2

If a digital input is selected for the main system, then this will be the only

digital source selectable for Zone 2. If an analogue source is playing in the

main system, then all digital sources will be selectable for Zone 2.

Remote control not working

Remote control not operating Check batteries

Remote control will not operate a

Cyrus CD player or tuner

CD, TU/DAB or AV button must be

pressed before sending a command

Your amplifier has a unique fault indication system to help you to diagnose

problems. There are three fault condition messages that may be displayed

in the event of a system fault – Output fault, Over-temperature and PSU

fault.

Possible fault Indications on the display during use, the display will show-

Output fault

The amplifier output has been

overloaded. This is usually due to a

short-circuit at the loudspeaker

terminals

Switch off the amplifier and check

that there are no short circuits in the

speaker wiring at the amplifier rear

panel or at the speaker terminals

Over-temperature

The amplifier has over-heated. This

may occur if the amplifier is driving

low impedance speakers, if the

volume is set too high for prolonged

listening, or if there is inadequate

ventilation for the amplifier

The amplifier will switch off until it

has cooled down. If this happens

regularly, try improving the

ventilation around the casing of the

amplifier. If the problem continues,

then the impedance rating of your

speakers may be too low.

PSU fault

This fault condition will be displayed

if there is a fault with the internal

power supply of the amplifier.

A PSU fault cannot be corrected by

the user. The amplifier should be

returned to your retailer.

If a fault condition still remains, return the amplifier (together with the PSX-

R if you are using one) to your Cyrus appointed retailer or an authorised

Service Centre.

WARRANTY

The warranty should be registered on-line within 8 days of purchase. No

Dealer or Distributor may vary the terms of this warranty, which is

personal to the original Purchaser and is not transferable.

Please retain the sales receipt as proof of purchase.

Warranty claims must wherever possible be made through the Dealer from

whom the equipment was purchased.

This warranty excludes:

• Damage caused through neglect, accident, misuse, wear and tear, or

through incorrect installation, adjustment or repair by unauthorised

personnel. Any unauthorised servicing will result in loss of warranty.

• Liability for damage or loss occurring in transit to or from the

purchaser.

• Consequential damage, loss or injury, arising from or in conjunction

with this equipment.

Equipment for attention under warranty should be consigned return

carriage paid. If returned equipment is found to comply with the published

specification, CYRUS reserves the right to raise a charge.

The above conditions do not affect your statutory rights as a consumer.

WEEE

This logo means that this product is not to be

disposed of with your household waste. This product

should be handed over to a designated collection

point to be recycled. Your cooperation in the correct

disposal of this product will contribute to the effective

usage of natural resources. For more information on

collection points, contact your disposal service or

City Hall.

1 2 ... 7 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Cyrus 8 DAC Instrucciones de operaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Amplificadores de audio Cyrus 8 DAC